Airblade™ technologyin a tap.
Wash and dryhands at the sink.
See it in action
Images
How to buy
With Airblade™ technology in a tap, hands can be dried at the sink in just 14 seconds.1 There's no need for users to move to a separate drying area, so no waste water dripped on the floor.
Other hand drying methods take up valuable wall and floor space. With the Dyson Airblade Wash+Dry hand dryer, there's room for extra toilet cubicles and other facilities.
Every second, up to 21 litres of air are forced through apertures up to 0.55mm wide. The result – 549km/h sheets of air that scrape water from hands, drying them hygienically in just 14 seconds.1
Saves you money
The Dyson Airblade Wash+Dry hand dryer costs an average of just $34 a year to run. That’s up to 78% less than other hand dryers, and up to 98% less than paper towels. (see calculations).
Find out more about running costs and use our calculator to see how much you could save by switching to Airblade™ technology.
$34
per year
to run
$157
$1,460
The Dyson Airblade Wash+Dry hand dryer takes 14 seconds to dry hands completely.1 So users spend less time in the washroom, and busy periods are easier to manage.
The Dyson digital motor V4 is one of the world's smallest fully integrated 1000W motors. It spins up to 81,000 times a minute, and is the only hand dryer motor powerful enough to make Airblade™ technology possible.
Dyson Airblade Wash+Dry hand dryers uses a HEPA filter that captures 99.95 of bacteria and viruses from the air used to dry hands (0.3 microns). So hands are dried with cleaner air, not dirty air.2
The HEPA filter removes airborne particles from the air. It has a grille to capture larger debris, a fleece layer to capture fluff and fibres, and a pleated HEPA media to capture paricles as small as 0.3 microns.2
Points to consider before installation
For more information please download a brochure.
Dry indoor environments only.Maximum operating elevation 2000m.
Dedicated 15 A supply per unit. Input voltage/frequency200-240V 50-60Hz.Rated power 1000W.
Water pressure between 1-8 bar.Pipe thread 1/2" BSP.
Minimum 100mm distance between floor and motor bucket. Dyson Airblade Wash+Dry wall hand dryer must use metal enclosure as supplied.
Have you got the right type of sink?
Click the link below to see our list of approved sinks.
For more information on machine dimensions, electrical supply and construction materials, download thetech spec.
Find out recommended mounting heights, clearance distances and more installation information by downloading the technical specification.
Hands are dried in 10-14 seconds.1
HEPA filters as standard.
Up to 80% less thanother hand dryers.
No trees cut down, no paper waste
Parts and labour
Dyson Airblade™ hand dryer range
Dyson Airblade Wash+Dry hand dryer range
Airblade™ technology in a tap. Wash and dry hands at the sink.
Hear from businesses that are already benefiting from Airblade™ technology.
Explore technical specifications, installation guides and information for architects.
Help and support for Airblade™ technology owners from aDyson Airblade™ hand dryer expert.
Buy or rent Airblade™ technology.
